STRIP COLLATED PINS AKN-144

STRIP COLLATED PINS AKN-144 PINS The knurled shank AKN-144 pins are supplied collated for use with the Aerico® 90 tool. These pins are typically used to fasten plywood, oriented strand board (OSB) or lumber to steel members ranging in thickness from 68mil (14ga) to 3/16" thick. Fastener length is determined such that the fastener point penetrates the steel by at least 3/8". Select either plastic or tape collated pins (25 pins/strip) for the Aerico® 90. See IAPMO UES ER-335 for performance data. Custom sizes and packaging is available for special requirements. Contact us for more information about lengths not shown below

Standards & Codes

IAPMO ER-335

STRIP COLLATED PINS AKN-144

Questions? Contact us

800-248-2376

Advantages

  • Broad Range
  • Excellent Service
  • Top Sales Team
Specifications

Additional Information

Pin Characteristics

Head Diameter0.300" (7.6 mm)
Nail Diameter
.140"
3.60 mm
Length
1 1/4”, 1 1/2”, 1 3/4”, 2” 2 1/4”
FinishMechanical Galvanized
Materialhigh carbon steel, heat treated
Shank Typesknurled
Strip Capacity25 pins
ToolsAerico® 90
Technical ReportsIAPMO ER-335
DisclaimerManufacturers

Packing Information

Quantity per Case3,750 (AKN-144-0225P 2,500; AKN-144-0062C 8,000)
Standards and Codes
IAPMO ER-335

This evaluation report recognizes ET&F pneumatic pins used to attach wood structural panel sheathing to cold formed steel framing of 20 GA. to 10 GA. thickness for horizontal diaphragm construction. Withdrawal and lateral strength design values are also provided for individual pins.