STEEL FRAMING PINS AKN-100-XXXXHA

STEEL FRAMING PINS AKN-100-XXXXHA

The STEEL FRAMING PINS AKN-100-XXXXHA series pins are designed specially for the ROCKFAST® E45 tool to attach plywood, oriented strand board (OSB) and fiber cement siding to cold formed steel from 97 mil (12 GA.) to 27 mil (22 GA.). These pins are finished with Aericote® 1000 coating which provides ten times the corrosion protection of electroplated zinc. When driven, the fastener separates completely from the sheet plastic collation leaving a clean fastening, especially important when face nailing siding. The 1" long pins can be used for select steel-to-steel applications of up to two layers of 54 mil (16 GA.). A special knurl pattern improves performance in steel-to-steel connections. Refer to IAPMO UES ER-335 for design values for horizontal diaphragm and shear wall construction. See ICC Reports ESR-2290 and ESR-1844 for design values for use face nailing James Hardie fiber cement siding. Select sizes of similar pins manufactured from 300 series stainless steel are available. These pins are limited in use to fastening to maximum 43 mil (18 GA.) steel. Contact us for details

PART NO. AKN-100-0100HA 1", AKN-100-0150HA 1-1/2"; AKN-100-0200HA 2"; AKN-100-0250HA 2-1/2"

Standards & Codes

ESR-1844
ESR-2290
IAPMO ER-335

Collated Pins

STEEL FRAMING PINS AKN-100-XXXXHA

    Questions? Contact us

    800-248-2376

    Advantages

    • Broad Range
    • Excellent Service
    • Top Sales Team
    Specifications

    Additional Information

    Pin Characteristics

    Collation Typeplastic sheet coil
    Head Diameter0.300" (7.6 mm)
    Nail Diameter
    .100"
    2.54 mm
    Length
    1 1/2", 2", 2-1/2"
    FinishAericote® 1000
    Materialhigh carbon steel, heat treated
    Nail HeadFull Round Head
    Shank Typesknurled
    Coil Capacity250 pins
    ToolsE45
    Technical ReportsESR-1844, ESR-2290, IAPMO ER-335

    Packing Information

    Quantity per Case2,000 (AKN-100-0250HA 2,000)
    Standards and Codes
    ESR-1844

    This report recognizes the use of ET&F pneumatic fasteners used to attach fiber cement HardiePanel® siding, manufactured by the James Hardie Building Products, to light gauge steel framing.

    ESR-2290

    This report recognizes the use of ET&F pneumatic fasteners used to attach fiber cement HardiePlank® siding, manufactured by the James Hardie Building Products, to light gauge steel framing and to concrete masonry units.

    IAPMO ER-335

    This evaluation report recognizes ET&F pneumatic pins used to attach wood structural panel sheathing to cold formed steel framing of 20 GA. to 10 GA. thickness for horizontal diaphragm construction. Withdrawal and lateral strength design values are also provided for individual pins.